Hard Drive Replacement - Appendix #8 - Lorex SG17LD800 Instruction Manual

Hard Drive Replacement - Appendix #8

Hard Drive Replacement - Appendix #8
The System comes with a pre-installed Hard Drive, however the unit will work with a replacement
single Hard Drive (up to 500GB).
NOTE: Make sure that the System is OFF and the power cable has been disconnected before
changing the Hard Drive.
Setting the New Drive to Master
• Refer to the General Jumper Pin Setting on HDD Surface (generally located on a sticker on
the top of the drive).
• Set the Jumper Pin Set to Master (1 Drive).
NOTE: Use a Hard Drive Model with a power supply rated UDMA66 or higher.
Connecting the IDE Cable
• Confirm the IDE Cable is securely connected within the System.
• The IDE Cable has Three Connectors:
Blue Color Connector: Must be Connected with Main Board.
Other Connectors: Connect to the HDD
76