Calibration Mode - Datamax E-Class E-4304 Operator's Manual

4.6 Calibration Mode

In 'Calibration Mode' the printer's buttons allows the printer to
'calibrate' the media for sensing of the Top of Form either automatically
or manually.
Note: If at any time you wish to discard your changes and revert back to the previous
calibration simply turn off the printer.
Note: Before calibrating, be sure the media sensor is set for the appropriate media
type, see section 4.4.2, also be sure the printhead is latched down and the cover
is closed.
Note: Printer and cutter faults are disabled during
Note: Factory Defaults can be restored, see section 5.7
E-4203/E-4204/E-4304
, but can still occur while printing "test" labels.
and
31