Stx Kb - Backfeed Time Delay; Stx K- - Top Of Form, Offset Distance; Stx Kd Database Configuration; Stx Ki - Gpio Input - Datamax DGL Programmer's Reference Manual

Chapter 3

STX Kb - Backfeed Time Delay

(Obsolete Extended System Command) .

STX K- - Top of Form, Offset Distance

(Obsolete Extended System Command ).

STX KD Database Configuration

(Obsolete Extended System Command ).

STX KI - GPIO Input

(Obsolete Extended System Command).

STX KM - Configure Internal Memory Module Size

(Obsolete Extended System Command ).

STX KO - GPIO Output

(Obsolete Extended System Command ).

STX KR - Reset Memory Configuration

(Obsolete Extended System Command ).

STX KS - Configure Scalable Font Cache Size

(Obsolete Extended System Command.)

STX KW - Configure Print Width Size

(Obsolete Extended System Command.)

STX M - Set Maximum Label Length

This command instructs the printer to travel this distance in search of top-of-
form (label edge, notch, black mark, etc.) before declaring a paper out fault.
The fault condition can occur if this value is set too close to the physical length
of the label (within 0.1inch/2.54mm). Therefore, it is good practice to set this
value at 2.5 to 3 times the actual label length used. The minimum value
should be at least 5" (127mm). (Not supported.)

STX O - Set Start of Print (SOP) Position

This command sets the point where printing starts relative to the selected
SOP Emulation (SOP Emulation may be enabled and selected using the
printer's Menu System). The position specified by this command emulates a
selected legacy printer's distance, as measured between the Media Sensor
and the Printhead burn line. This value is independent of the <STX>f
command. If the SOP Emulation is set to 'Disabled', this command is ignored.
(Not supported.)
30