Vertical Dpi Adjust; Command Ignore Menus; Length Cmd (Stxc); Heat Cmd (H) - Datamax DGL Programmer's Reference Manual

Chapter 1
PPI/DGL SETUP Menu

Vertical DPI Adjust

This option fine adjusts the resolution used to scale the page elements/
coordinates. In cases where the printed label length is incorrect, the vertical
resolution value DGL uses for calculations can be fine adjusted by this menu
between -100 and +100. Negative values result in a lower DPI value and thus
a longer label. Positive values result in a higher DPI value, and thus a shorter
label. Note that this adjustment does not affect the size of images and
downloaded bitmap fonts.
•
0 (-100 to +100).
The default is 0.

Command Ignore Menus

The Admin User menus allow ignoring of several configuration commands in
the host data. This allows using their corresponding front-panel settings,
without being overridden by host commands.
The default is to process all commands.

Length Cmd (STXc)

Allows the user to disable the Length Command.

Heat Cmd (H)

Allows the user to disable the Heat Command.

Speed CMD (P,S)

.Allows the user to disable the speed commands (Print, Feed, and Reverse).

Cut Cmd (o,:,c)

Allows the user to disable the commands affecting the cutter.

Soft Switch (V)

Allows the user to disable the 'Software Switch Settings' Command (this
command enables Cut or Tear-Off mode, or disables both by selecting
Continuous mode).

Sensor Cmd (e,r)

Allows the user to disable the commands that select the Gap / Mark sensor
(<STX>e and <STX>r).

Format Attr.(A)

Allow the user to disable the commands that select the Format Attribute.
16