Stx Kf - Select Factory Defaults; Stx Kf - Set Present Distance; Stx Kp - Module Protection; Stx Kq - Query Memory Configuration (New Format) - Datamax DGL Programmer's Reference Manual

power-up the printer while pressing the PAUSE and CANCEL keys; or, 3) via
the printer's menu system entry System Settings / Set Factory Defaults. (Not
supported.)

STX KF - Select Factory Defaults

This command restores the printer's configuration to the "factory default"
settings. These factory default values may be either the Datamax default
settings or the configuration file previously specified in the <STX>Kd
command. (Not supported.)

STX Kf - Set Present Distance

This command specifies an additional amount to advance the label after
printing. (Not supported.)

STX Kp - Module Protection

This command controls memory module protection. When "protected", a
module will ignore format, downloads and delete commands. This command
can be useful to add data to Datamax reserved modules, Z (ILPC) and Y
(EFIGS). (Not supported.)
STX KQ - Query Memory Configuration
This command causes the printer to transmit its internal DRAM memory
configuration to the host device. The transmitted data provides information
regarding the total amount of installed internal DRAM, the amount available
for configuration and the amount currently assigned to specific functions or
entities. (Reported values are not all actual values.)

STX Kq - Query Memory Configuration (new format)

This command causes the printer to transmit its internal DRAM memory
configuration to the host device. The transmitted data provides information
regarding the total amount of internal DRAM installed, the amount available
for configuration, and the amount currently assigned to specific functions or
entities. (Not supported.)

STX Kr - Resettable Counter Reset

This command resets the internal counters. Follow this command with an
<SOH>U command to retain the reset or the counters will revert to the
previous values after cycling power. (Not supported.)

STX KV - Verifier Enable/Disable

This command allows the verifier (option, if installed), to be enabled and
disabled. (Not supported.)

STX Kx - Delete Configuration File

This command deletes the specified configuration file. (Not supported.)
29