Step Nine - Turn On The Avr - Harman Kardon AVR 147 Owner's Manual

INSTALLATION
Step Nine – Turn On the AVR 147
Two steps are required the first time you turn on the AVR 147.
1. Gently press the Master Power Switch until the word OFF is no longer
visible. The Power Indicator above the two power switches should
light up in amber, indicating that the AVR is in Standby mode and is
ready to be turned on. See Figure 35. Normally, you may leave the
Master Power Switch in the ON position, even when the receiver is
not being used.
2. There are several ways in which the AVR 147 may be turned on from
Standby mode.
a) Press the Standby/On Switch on the front panel. See Figure 35.
b) Press the Source Select Button on the front panel. See Figure 36.
Figure 36 – Source Select Button
c) Using the remote, press any one of these buttons: AVR, DVD/CD,
TAPE/The Bridge, HDMI 1/HDMI 2, VID1, VID2, VID3, XM, AM/FM
or 6CH. See Figure 37.
NOTE: Any time you press one of the Input Selectors on
the remote (i.e., DVD/CD, TAPE/The Bridge, HDMI 1/HDMI 2,
VID1, VID2 or VID3), the remote will switch modes so that it will
only transmit the codes programmed to operate that device. In
order to control the receiver, you will need to press the AVR
button to return the remote to AVR mode.
26
Figure 35 – Power Switches
Figure 37 – AVR and Input Selectors