Front Panel Assembly - HP xw4100 Service And Technical Reference Manual

removal and replacement procedures

4.3.8 front panel assembly

To remove the front panel assembly:
1. Remove the front bezel.
2. Disconnect the front panel assembly cable from the system board.
3. Remove the two screws 1 that hold the assembly shield to the chassis as shown in the
following illustration.
4. Slide the front panel assembly 2 (with shield attached) out about two inches away from the
chassis.
5. Remove the two screws 3 that hold the shield and assembly together and separate the shield
away from the front panel assembly 4.
Å
WARNING: The next step requires the removal of cables through the chassis. Some edges on the
chassis may be sharp. Care must be taken when removing these cables.
6. Slide the front panel cables through the chassis and out the front of the unit.
To replace the front panel assembly, reverse the previous steps.
4–12 hp workstation xw4100 service and technical reference guide