Jumpers; U320 Scsi Hard Drive - HP xw4100 Service And Technical Reference Manual

SCSI Devices

jumpers

The specifications included below are the standard drive configurations.

U320 SCSI hard drive

1. Drive intended only for non-pluggable applications. Migration to a
hot-pluggable drive tray is not supported.
2. All jumper and switch settings shown in the factory default setting, including
those not labeled.
3. Termination is disabled/removed.
After changing the jumper settings, reboot the workstation to recognize the new address.
NOTE:
B–4
SCSI ID settings
SCSI ID bit 2
0
1
2
3
4 jumper
5 jumper
6 jumper
default settings
signal description
S Start unit command
enabled
P Parity enabled
W Write protect disabled
X Switch data transfer
enabled
hp workstation xw4100 service and technical reference guide
bit 1 bit 0
jumper
jumper
jumper jumper
jumper
jumper
jumper
jumper
jumper