System Configuration menu
NOTE:
Some of the listed System Configuration options may not be supported by your computer.
Select
Language
Boot Options
Device Configurations
148
Chapter 5 Computer Setup
To do this
Change the Computer Setup language.
Set a Startup Menu delay (in seconds).
●
Enable/disable Custom Logo (disabled by default).
●
Enable/disable Display Diagnostic URL (enabled by
●
default).
Enable/disable CD-ROM boot (enabled by default).
●
Enable/disable SD Card boot (enabled by default).
●
Enable/disable floppy boot (enabled by default).
●
Enable/disable PXE Internal NIC boot (enabled by
●
default).
Set the Express Boot Popup delay in seconds.
●
Set the boot order.
●
Enable/disable USB legacy support (enabled by default).
●
When enabled, USB legacy support allows the following:
Use of a USB keyboard in Computer Setup even
◦
when a Windows® operating system is not running.
Startup from bootable USB devices, including a
◦
hard drive, diskette drive, or optical drive
connected by a USB port to the computer.
Select a parallel port mode: ECP (Enhanced Capabilities
●
Port), standard, bidirectional, or EPP (Enhanced Parallel
Port).
Enable/disable fan always on while connected to an AC
●
outlet (enabled by default).
Enable/disable LAN Power Save (select models only).
●
When enabled, saves power by turning off the LAN
when not in use (enabled by default).
Enable/disable Data Execution Prevention. When
●
enabled, the processor can disable some virus code
execution, which helps to improve computer security.
SATA (Serial Advanced Technology Attachment) device
●
mode. The following options are available:
AHCI (Advanced Host Controller Interface)
◦
IDE (Integrated Drive Electronics)
◦
RAID (select models only)
◦