HP OmniBook 2100 Reference Manual page 112

Troubleshooting
If you can't boot from a floppy in the floppy disk drive
Make sure the floppy drive is seated correctly—remove and reinsert.
Check the boot order in BIOS Setup.
1. From the Start menu, shut down, then restart the OmniBook.
2. When you see the HP logo, press F2 to enter the BIOS Setup utility.
3. Open the Boot menu. The default boot order is
Diskette Drive
Hard Drive
CD-ROM Drive
4. If Diskette Drive is not option 1, use the arrow keys to select Diskette Drive.
5. Press F6 to move up (or F5 to move down) in the list.
6. Press F10 to Save and Exit the BIOS Setup utility.
Check that the Floppy Boot option in the BIOS Setup utility is enabled.
Reset the OmniBook.
If the Zip drive isn't working
Make sure the Zip disk is inserted correctly.
Reset the OmniBook.
Make sure the Zip drive module is seated correctly—remove and reinsert.
7-4