Hold-Downs - Grizzly G5912Z Owner's Manual

Hold-Downs

Hold-downs are used to hold the workpiece flat on
the table and snug against the fence as shown in
Figure 20.
To assemble the hold-downs:
1.
Slide a hold-down bar into each of the cast
iron hold-down brackets.
2.
Insert the bracket pole into the fence bracket
and hold-down bracket.
3.
Partially screw the handle into the hold-down
brackets.
4. Slide two hold-down brackets into the miter
slot. Position these so they are across from
the fence mounted hold-downs similar to
those in Figure 21. Tighten these in place
with the knob on top of each miter hold-
down.
5.
Position the hold-downs according to the size
of your workpiece.
6. Tighten the handles to secure the hold-
downs.
G5912Z/G7214Z Heavy-Duty Shaper
Figure 20. Hold-downs on workpiece.
Figure 21. Overview of hold-downs in place.
-17-