Table of Contents
Advertisement
Hold-Downs
Hold-downs are used to hold the workpiece flat
and snug against table as shown in Figure 18. To
assemble the hold-downs:
1.
Slide a hold-down plate into each of the cast
iron hold-down brackets.
2.
Insert the bracket pole into the fence bracket
and hold-down bracket.
3.
Partially screw the handle into the hold-down
brackets.
4.
Position the hold-downs according to the
size of your workpiece.
5.
Tighten the handles to secure the hold-
downs.
Figure 18. Hold-down on workpiece.
-16-
Miter Assembly
The miter gauge for the Model G8621 features a
clamp and special fence. The miter gauge
assembly can be mounted on either end of the
table, depending on the type of desired cut or cut-
ting direction. To mount the miter gauge and its
fence:
1.
Locate the threaded holes on either side of
the table.
2.
Install the push shaft as shown in Figure 19.
Figure 19. Installing the push shaft.
3.
Now, slide the miter gauge down the push
shaft as in Figure 20.
Figure 20. Installing the miter gauge.
G8621 Heavy-Duty Sliding Table Shaper
Advertisement
Table of Contents
