Guard; Fence Assembly - Grizzly G5912Z Owner's Manual

Guard

To mount the cutter guard to the table:
1. Place the guard over the threaded holes on
the table.
2.
Insert the shaft guide with a washer into the
guard as shown in Figure 13, and thread the
shaft guide clockwise to secure the guard to
the table.
Figure 13. Inserting shaft guide into guard.
3.
Insert the adjustment guide into the screw
bracket. Line up the shaft groove shown in
Figure 12 with the center bolt and screw the
bolt into the groove as shown in Figure 14.
Do not completely tighten the bolt. This will
allow the shaft to spin without coming out.
Figure 14. Tightening bolt into shaft groove.
G5912Z/G7214Z Heavy-Duty Shaper

Fence Assembly

To mount the fence brackets to the guard
body:
1. Thread the adjustment shaft into the fence
bracket as shown in Figure 15.
Figure 15. Adjustment guide to fence bracket.
2. Insert the adjustment handle (Figure 16) into
the fence bracket, and thread it into the guard
body.
Figure 16. Adjustment handle.
-15-