Table Travel - Grizzly G3616 Owner's Manual

Table Travel

The table of the Model G3616/G3617 can be
moved in 3 axes: Cross Feed, Longitudinal
Feed, and Knee Feed. Each of these axes
are handwheel controlled (see Figure 28). All
handwheels are graduated to accurately position
the workpiece in relation to the tool.
Knee
Handle
Figure 28. Table travel handwheel locations.
Cross Feed
The cross feed is controlled by the center
handwheel and two locks on the right side of the
mill, under the table (see Figures 28 & 29).
Cross Feed Locks
Figure 29. Cross feed lock locations.
G3616/G3617 Mill
Longitudinal
Handwheels
Cross Feed
Handwheel
Longitudinal Feed Control
The longitudinal feed is controlled by two
handwheels, one at each end of the table, and two
locks at the front of the table (see Figures 28 &
30).
Longitudinal Travel Locks
Figure 30. Longitudinal feed lock locations.
Knee Feed
The knee feed is controlled by one handle, just off
center at the front of the machine, and two locks
on the right side of machine where the knee meets
the ways (see Figures 28 & 31).
Knee Travel Locks
(2nd lock off picture)
Figure 31. Knee feed lock locations.
29