Table Inserts - Grizzly G1026 Instruction Manual

4.
Place the spindle/drawbar into the spindle
cartridge at the top of the table. Line up the
keyway on the spindle with the locating pin at
the top of the spindle cartridge. You will feel
the spindle seat itself. See Figure 10.
Figure 10. Inserting the spindle into place.
Make sure the spindle keyway and pin are
aligned and properly seated before tighten-
ing the drawbar nut. Improper assembly can
create an unsafe condition and possible
injury to the operator.
5.
Thread the drawbar nut, tapered side up, onto
the bottom of the drawbar until it stops below
the spindle housing cartridge. See Figure 11.
Figure 11. Nut threaded onto drawbar.
G1026 Heavy-Duty Shaper
��������
���������
6.
Place the spindle wrench on top of the
spindle, so it fits over the head of the spin-
dle. Place a 17mm wrench on the drawbar
nut. See Figure 12.
Figure 12. Tightening the drawbar nut.
7.
Hold the spindle in place and tighten the
drawbar nut. DO NOT use excessive force.

Table Inserts

The Model G1026 is supplied with three table
inserts which give you four possible opening
diameters in the shaper table surface. Use the
smallest opening that a particular cutter will allow.
This offers more support for the workpiece and
reduces the amount of chips that can fall into the
machine.
The correct spindle opening will also allow any
unused portion of the cutter to remain below the
table surface—increasing operator protection.
There are two aluminum table inserts and one
cast iron table insert. The cast iron table insert
must be flush with the top of the table.
To adjust the insert:
1.
KEEP SHAPER DISCONNECTED FROM
POWER!
2.
Remove the three Phillips head screws that
hold the cast iron insert in place.
-15-