Power Controls - Grizzly G0603X Owner's Manual

Power Controls

Table adjustments can be made with the power/
table controls, or in conjunction with the digital
control.
The digital control adds these convenient fea-
tures:
• Move the table to a one-time preset position.
• Add or subtract distance from the current
table position.
• Move the table to one of ten preset locations
stored in digital memory.
There are two LED readouts on the digital con-
trol. The top LED shows the target position value
intended for the table, if one is entered, and the
bottom LED shows the actual position of the
table.
� The readout values can be expressed either in �
millimeters or inches with the use of the MM/INCH
key . The corresponding LED light on this key
��
�
����
will show which measurement is active.
�
To move the table with the power/table con-
trols only:
�
1.
Press the TABLE UP or TABLE DOWN but-
ton on the power/table control.
2. Table movement will stop when the button is
released.
G0603X 25" Extreme Series Planer
The digital control has two modes of operation—
manual and single.
In MANUAL mode, the table can be moved either
with the power/table control buttons or the digital
control keypad.
To use the digital control keypad in manual
mode to move the table:
1.
Press the MANUAL/SINGLE key
select MANUAL mode—the light on this key
will blink.
��� ���
• Press the "9" key
������
�
������
pad to move the table up.
���
�
����
•
Press the "8" key
������
������
pad to move the table down.
�
�����
����
2.
Release the key to stop table movement.
���
����
�����
The SINGLE mode of the digital control provides
precise movement of the table to a preset posi-
����
tion.
To move the table to a one-time preset posi-
tion:
1. On the digital keypad, press the MANUAL/
SINGLE key
��� ��� ���
the light on this key will be off.
������
� �
������
2. Press the PROGRAM key
blink in the top target window.
� �
����
3. Using the numerical keypad, enter the target
� value for the table position. �
�����
��� ���
4.
Press the ENTER key
���
�
����
START key
������
�
������
5.
Press the START key
�
����
to the target position.
Note: To cancel the table movement before it has
�
�����
reached the target value, press the STOP key
. To restart the procedure, you will have to re-
���
����
enter the target value again.
���
on the digital key-
� � �
��� ���
��
� �
����
on the digital key-
� � �
� �
� � �
�
�
� � �
�
���
�
��� ��� ���
���
to select SINGLE mode—
������
� �
������
������
������
� �
����
� �
—an LED will
����
��� ��� ���
� �� �
�����
�
����
�����
������
��� ���
� �
������
���
�
����
�
����
������
�
� �
���� ������
���
�
—the light on the
will blink. �
����
� �
�����
� � �
to send the table
�
�����
���
�
����
��
� �
����
���
����
� �
�
�
��� ���
to
������
�
������
�
����
�
�����
���
����
�
��
����
��� ���
� �
� �
��
�
����
� �
�
� �
���
� �
�
���
�
� �
��
�
����
� �
�
�
� �
�
�
-25-