Adjust Chipbreaker; Adjust Depth Scale - Grizzly G0603X Owner's Manual

Adjust Chipbreaker

Distance Below Cutterhead at BDC:
Chip Breaker ............................................. 0.020"
Tools Needed:
Rotacator ........................................................... 1
Hex Wrench 8mm .............................................. 1
Metal Shims ........................................ as needed
To set the height of the chipbreaker:
1. DISCONNECT THE
POWER!
2. Follow the same methods for determining the
height of the chipbreaker in relation to the
cutterhead as detailed in the previous proce-
dural block (reference Page 38).
3. If an adjustment is necessary to bring the
height of the chipbreaker to the specification
listed above:
a. Remove the cap screws on each end of
the chipbreaker (see Figure 36)
b. Place the required metal shim(s) between
the chipbreaker and the headstock cast-
ing.
c. Replace and tighten the cap screws
removed in Step 3a.
Cap Screw
Metal Shims
(if needed)
Figure 36. Chipbreaker mounting to headstock
casting (right side shown).
-40-
Qty
PLANER FROM

Adjust Depth Scale

Tools Needed:
Hex Wrench 4mm .............................................. 1
The pointer on the depth scale (see Figure 37)
should indicate the same value as shown in the
bottom actual position LED window of the digital
control.
Cap Screws
Figure 37. Depth scale pointer.
To adjust the depth scale pointer:
1.
Loosen the two cap screws that secure the
pointer.
2.
Adjust the pointer and retighten the cap
screws.
G0603X 25" Extreme Series Planer
Qty
Depth Scale
Pointer