Table Extension Wings - Grizzly G0603X Owner's Manual

Table Extension
Wings
Components and Hardware Needed:

Table Extension Wings ...................................... 2

Open End Wrench 17 x 19mm .......................... 1
Hex Wrench 5mm .............................................. 1
Straightedge 4' (or longer) ................................. 1
Hex Bolts M12-1.75 x 50 ................................... 6
Flat Washers 12mm .......................................... 6
Set Screws M10-1.5 x 20 .................................. 6
Table extension wings are heavy and could
cause personal injury if dropped during
installation. Have an assistant hold the table
extension wings while you fasten them to
the planer.
To attach the table extension wings:
1. With the help of an assistant, attach the table
extension wings to the planer table (see
Figure 13) with the hex bolts and the flat
washers. Hand tighten the bolts for now.
2. Install the set screws (see Figure 13) in the
holes in the bottom of the wings.
-18-
Hex Bolts
Qty
Figure 13. Table extension wing fasteners and
3.
Using the straightedge as a guide (see
Figure 14) and the set screws for leveling
control, position the extension wings even
and level with the table, then fully tighten the
hex bolts.
Figure 14. Leveling extension wings and table.
Set Screws
leveling set screws.
G0603X 25" Extreme Series Planer