Controls & Components - Grizzly G1021X2 Owner's Manual

controls &
components
to reduce your risk of
serious injury, read this
entire
using machine.
refer to figures 1–3 and the following descrip-
tions to become familiar with the basic controls
and components of this machine. understanding
these items and how they work will help you
understand the rest of the manual and stay safe
when operating this machine.
a
g1021X2
d
g1021z
figure 1. table elevation and feed controls.
A. control Panel
(G1021X2):
— green Start button turns motor ON
when pressed.
— power indicator light illuminates when
motor turned ON.
— red Stop button turns motor OFF when
pressed; for safety purposes, this button
will remain depressed and prevent restart-
ing until reset. reset by rotating clockwise
until it pops out.
-4-
manual bEfORE
B
C
E
F
for Magnetic Switch
b. table height handwheel: raises and low-
ers table to accommodate different workpiece
thicknesses. one complete revolution moves
the table approximately 2mm (0.08").
c. table Locks: Secure table height position.
D. Depth Limiter: limits depth of cut to a maxi-
mum of ⁄ " at full width.
1
8
E. feed Rate control Knob: Selects 20 FpM
feed rate when pushed in and 16 FpM feed
rate when pulled out.
f. Magnetic ON/Off Switch (G1021Z):
— green start button turns motor ON when
pressed.
— red Stop button turns motor OFF when
pressed; for safety purposes, this button
will remain depressed and prevent restart-
ing until reset. reset by rotating clockwise
until it pops out.
g
figure 2. Example of return rollers and dust port.
G. Return Rollers: assist sliding workpiece
back to operator following planing operation.
h. Dust Port: Connects to a dust collection
system to extract shavings and dust during
operation. dust port size 4".
G1021X2 & G1021Z (Mfd. Since 08/16)
h