Gigabyte GA-VM900MC User Manual page 72

Step 3:
When Setup correctly recognizes the driver in the floppy disk, a controller menu similar to Figure 3
below will appear. Use the arrow keys to select one of the items displayed and press <Enter>. If you
want to install Windows XP, use the ARROW keys to select VIA V-RAID Controller Series (Windows
XP/SRV2003) and press ENTER. Then it will begin to load the SATA Raid driver from the floppy
(Note)
disk.
Windows Setup
You have chosen to configure a SCSI Adapter for use with Windows,
using a device support disk provided by an adapter manufacturer.
Select the SCSI Adapter you want from the following list, or press ESC
to return to the previous screen.
ENTER=Select F3=Exit
If a message appears saying one or some file(s) cannot be found, please check the floppy disk
or copy the correct SATA RAID driver again from the motherboard driver disk.
When the screen as shown below appears, press <Enter> to continue the driver installation from
the floppy disk. The driver installation will be finished in about one minute.
Windows Setup
Setup will load support for the following mass storage device(s):
VIA V-RAID Controller Series (Windows XP/SRV2003)
* To specify additional SCSI adapters, CD-ROM drives, or special
disk controllers for use with Windows, including those for
which you have a device support disk from a mass storage device
manufacturer, press S.
* If you do not have any device support disks from a mass storage
device manufacturer, or do not want to specify additional
mass storage devices for use with Windows, press ENTER.
S=Specify Additional Device ENTER=Continue F3=Exit
(Note) For 64-bit Windows Operating System, please select VIA V-RAID Controller Series
(Windows XP/SRV2003-x64).
GA-VM900MC Motherboard
VIA V-RAID Controller Series (Windows XP/SRV2003)
VIA V-RAID Controller Series (Windows XP/SRV2003-x64)
VIA V-RAID Controller Series (Windows 2K)
VIA V-RAID Controller Series (Windows NT4)
Figure 3
Figure 4
- 72 -