Unix Configuration; Before Setup; Using The "Lp"/"Lpr" Commands; Using The "Rsh"/"Rcp"/"Ftp" Commands - Ricoh DSc332 Operating Instructions Manual

This section explains how to set up a network printer and check print status us-
ing UNIX.
Limitation
❒ To print from a UNIX workstation, use a file that the printer supports.

Before Setup

Setup varies depending on the printing commands. Be sure to make settings ac-
cordingly.

Using the "lp"/"lpr" commands

A A A A
Use the installation shell script to register the device option, as well as the
printer host name and IP address.
See p.4 "Using the Installation Shell Script".
B B B B
Start printing.
See p.14 "Printing Methods".

Using the "rsh"/"rcp"/"ftp" commands

A A A A
Edit the host file to register the printer host name and IP address.
B B B B
Start printing.
See p.14 "Printing Methods".
Reference
For information about host file editing, see p.9 "After Executing the Instal-
lation Shell Script".
Note
❒ If you cannot edit the host file, use the install shell script to register the host
name.

1. UNIX Configuration

3