Ricoh DSc332 Operating Instructions Manual page 1040

Appendix
Commands Topics of setting
route get
{destina-
*1
tion }
route active
{host | net}
destination
on/off
route add
default
*1
gateway
route flush
*1
IP address
SLP
Use the "slp" command to configure
SLP settings.
You can search the NetWare server
using SLP in the PureIP environment
of NetWare5/5.1, 6. Use the "slp"
command to configure the value of
TTL used by the SLP multi-cast-pack-
et.
Note
9
❒ The default value of TTL is "1". A
search is executed only within a lo-
cal segment. If the router does not
support multi-cast, the settings are
not available even if the TTL value
is increased.
❒ The acceptable TTL value is 1 - 255.
msh> slp ttl {1 - 255}
106
Displays only route informa-
tion corresponding to a spec-
ified destination. When the
destination is unspecified, all
routing information is dis-
played.
You can turn the specified
destination on or off. Host be-
comes the default.
You can set the default gate-
way address.
Deletes all routing informa-
tion.
SPRINT
Use the "sprint" command to view
and configure SCSI print (SBP-2) on
IEEE 1394.
Limitation
❒ You can use this function when the
optional IEEE 1394 interface board
is installed.
❖ ❖ ❖ ❖ Viewing settings
The following command displays
the current IEEE 1394 (SCSI print)
settings:
msh> sprint
❖ ❖ ❖ ❖ Bidirectional configuration for IEEE
1394 (SCSI print)
msh> sprint bidi {on | off}
Use this setting to select whether
IEEE 1394 (SCSI print) is bidirectional
or not. The default is "on".
Setting IEEE 802.11b
Use the "wiconfig" command to con-
figure IEEE 802.11b settings.
Limitation
❒ You can make settings when in-
stalling the optional IEEE 802.11b
interface unit.
❖ ❖ ❖ ❖ View settings
The following command displays
the current IEEE 802.11b settings.
msh> wiconfig
The following command displays
the IEEE 802.11b card information.
msh> wiconfig cardinfo
Note
❒ If the IEEE 802.11b interface is
not working correctly, the op-
tional IEEE 802.11b interface unit
information is not displayed.