Installing The Switch On A Table, Shelf, Or Desk; Installing The Switch On A Wall; Attaching The Brackets To The Switch - Cisco WS-C2950T-48-SI Hardware Installation Manual

Chapter 2 Installation

Installing the Switch on a Table, Shelf, or Desk

Before placing the switch on a table, shelf, or desk, locate the adhesive strip with rubber feet in the
mounting-kit envelope, and attach four rubber feet to the recessed areas on the switch bottom. Place the
switch on a table, shelf, or desk near an AC power source or DC-input power source.
Start the terminal-emulation software and provide power to the switch. See the getting started guide for
instructions.

Installing the Switch on a Wall

To comply with safety regulations, mount switches on a wall with the front panel facing up.
Warning
Statement 266
If an RPS is not connected to the switch, install an RPS connector cover on the back of the switch.
Warning
Statement 265
You can mount the Catalyst 2950 switch to a wall in a face-up configuration. To attach the switch to a
wall, follow the procedures in this section.
1.
2.
3.

Attaching the Brackets to the Switch

Use the supplied Phillips flat-head screws to attach a bracket to the switch.
attach the bracket to one side of the switch. Follow the same steps to attach the second bracket to the
opposite side of the switch.
Figure 2-18 Attaching Brackets for Wall-Mounting for the Catalyst 2950 Switch
OL-6156-01
Attaching the Brackets to the Switch, page 2-17
Attaching the RPS Connector Cover, page 2-18
Mounting the Switch to a Wall, page 2-18
Figure 2-18
Phillips
truss-head
screws
Catalyst 2950 Switch Hardware Installation Guide
Installing the Switch
shows how to
2-17