Installation; Preparing For Installation - Cisco WS-C2950T-48-SI Hardware Installation Manual

Installation

This chapter describes how to install your switch, interpret the power-on self-test (POST), and connect
the switch to other devices. Read these topics, and perform the procedures in this order:
•
•
•
•
•
•
•
•
•
•
•

Preparing for Installation

This section provides information about these topics:
•
•
•
Warnings
For translations of these warnings in several languages, see the Regulatory Compliance and Safety
Information for the Catalyst 2950 Switch.
Attach only the Cisco Redundant Power Supply (RPS) (model PWR300-AC-RPS-N1) to the RPS
Warning
receptacle. Statement 100B
OL-6156-01
Preparing for Installation, page 2-1
Verifying Switch Operation, page 2-6
Installing the Switch, page 2-7
Installing the GBIC Modules, page 2-22
Installing and Removing SFP Modules, page 2-23
Connecting to 10/100 and 10/100/1000 Ports, page 2-27
Connecting to 100BASE-FX and 1000BASE-SX Ports, page 2-29
Connecting to an LRE Port, page 2-30
Connecting to GBIC Module Ports, page 2-35
Connecting to SFP Modules, page 2-38
Where to Go Next, page 2-40
Warnings, page 2-1
Installation Guidelines, page 2-4
Verifying Package Contents, page 2-5
C H A P T E R
Catalyst 2950 Switch Hardware Installation Guide
2
2-1