Entering the Initial Configuration Information
If you want to save the configuration and use it the next time the switch reboots, save it
in nonvolatile RAM (NVRAM) by selecting option 2.
Enter your selection [2]:2
Make your selection, and press Return.
After you complete the setup program, the switch can run the default configuration that you created. If
you want to change this configuration or want to perform other management tasks, use one of these tools:
CLI
•
Device manager from your browser (for one switch)
•
Network Assistant (for one or more switches)
•
To use the CLI, enter commands at the Switch> prompt through the console port by using a
terminal-emulation program or through the network by using Telnet. For configuration information, see
the switch software configuration guide or the switch command reference.
To use the Network Assistant, see the Getting Started with Cisco Network Assistant guide.
Catalyst 2950 Switch Hardware Installation Guide
D-8
Appendix D
Configuring the Switch with the CLI-Based Setup Program
OL-6156-01