Cisco WS-C2950T-48-SI Hardware Installation Manual page 72

Installing and Removing SFP Modules
Figure 2-32 Using the Mylar Tab Latch to Remove an SFP Module from a Slot
1 9 2 0
2 1 2 2
If the module has an actuator button latch, use your thumb to push inward on the wedge to free the
•
locking pin, and use your index finger to grip the ridge on top of the SFP module. Pull straight out
to remove the module.
Figure 2-33 Using the Actuator Button Latch to Remove an SFP Module from an SFP Module Slot
1 9 2 0
If the module has a bale-clasp latch, pull the bale out and down to eject the module. If the bale-clasp
•
latch is obstructed and you cannot use your index finger to open it, use a small, flat-blade
screwdriver or other long, narrow instrument to open the bale-clasp latch.
Figure 2-34 Removing a Bale-Clasp Latch SFP Module by Using a Flat-Blade Screwdriver
Grasp the SFP module between your thumb and index finger, and carefully remove it from the module
Step 5
slot.
Place the removed SFP module in an antistatic bag or other protective environment.
Step 6
Catalyst 2950 Switch Hardware Installation Guide
2-26
2 3 2 4 C a ta ly s
t 2 9 5 0
SE RI ES L R E
1
2
1
2
2 1 2 2
2 3 2 4 C a ta ly s
t 2 9 5 0
L R E
SE RI ES
1
2
1
2
1 9 2 0
2 1 2 2
2 3 2 4 C a ta ly s
t 2 9 5 0
L R E
SE RI ES
1
1
Bale clasp
2
2
Chapter 2 Installation
OL-6156-01