Power Connectors; Internal Power Supply Connector; Dc Power Connector - Cisco Catalyst WS-C2924-XL Hardware Installation Manual

Chapter 1 Product Overview
Figure 1-13 Catalyst 2924M XL Rear Panel
C O N SO
LE
Note

Power Connectors

Internal Power Supply Connector

DC Power Connector

78-6461-04
RE FE R
TO M AN
BE FO RE UA L
CO NN
EC TI NG
PO W ER
The Cisco RPS does not support the Catalyst 2924M XL DC switch.
You can provide power to the switch either through the internal power supply or
through the Cisco RPS.
The internal power supply is an autoranging unit that supports input voltages
between 100 and 240 VAC. If you plan to use the internal power supply, use the
supplied AC power cord to connect the AC power connector to an AC power
outlet.
The Catalyst 2924M XL DC switch has an internal DC-power converter. It has
dual feeds (A and B) that are diode-OR-ed into a single power block. For
installation instructions, see the
page 2-29.
IN PU T:
36 - 72
CU RR
EN T: 4-
2A
A
B
+ -
+
-
D C IN PU
T
"Wiring the DC-Input Power Source" section on
Catalyst 2900 Series XL Hardware Installation Guide
Power Connectors
1-21