Hungary; Installation Guidelines - Cisco Catalyst WS-C2924-XL Hardware Installation Manual

Preparing for Installation

Hungary

Installation Guidelines

Caution
Warning
Catalyst 2900 Series XL Hardware Installation Guide
2-6
This equipment is a Class A product and should be used and installed properly
according to the Hungarian EMC Class A requirements (MSZEN55022). Class A
equipment is designed for typical commercial establishments for which special
conditions of installation and protection distance are used.
Figyelmeztetés a felhasználói kézikönyv számára:
Ez a berendezés "A" osztályú termék, felhasználására és üzembe helyezésére a
magyar EMC "A" osztályú követelményeknek (MSZ EN 55022) megfeleloen
kerülhet sor, illetve ezen "A" osztályú berendezések csak megfelelo
kereskedelmi forrásból származhatnak, amelyek biztosítják a megfelelo speciális
üzembe helyezési körülményeket és biztonságos üzemelési távolságok alkal-
mazását.
The switch can be installed on a table or shelf, in a rack, or on a wall.
Before installing the switch, first verify that the switch is operational by powering
it on and running POST. Follow the procedures in the
and Running POST" section on page
There are no serviceable parts inside the unit. Removing screws, cover, or
otherwise dismantling the unit voids the warranty.
Unplug the power cord before you work on a system that does not have an on/off
switch.
When determining where to place the switch, be sure to observe these guidelines:
For 10/100 ports, cable lengths from the switch to connected devices are up
•
to 328 feet (100 meters).
For 100BASE-FX ports, cable lengths from the switch to connected devices
•
are up to 1351 feet (412 meters) for half-duplex connections and less than
6561 feet (2 kilometers) for full-duplex connections.
"Powering On the Switch
2-24.
Chapter 2 Installation
78-6461-04