Cisco Rps Connector - Cisco Catalyst WS-C2924-XL Hardware Installation Manual

Power Connectors
Caution

Cisco RPS Connector

Note
RPS Connector on the Catalyst 2912 XL, 2924C XL, 2924 XL, 2924MF XL, and 2924M XL Switches
Warning
Note
Catalyst 2900 Series XL Hardware Installation Guide
1-22
You must connect the Catalyst 2924M XL DC switch only to a DC-input power
source that has an input supply voltage from -36 to -72 VDC. If the supply voltage
is not in this range, the switch might not operate properly or might be damaged.
Specific Cisco RPS models support specific Catalyst 2900 XL switches:
Cisco RPS 600 (model PWR600-AC-RPS)—supports the Catalyst 2912 XL,
•
2924C XL, 2924 XL, 2924MF XL, and 2924M XL switches.
Cisco RPS 300 (model PWR300-AC-RPS-N1)—supports the Catalyst
•
2912 LRE XL and 2924 LRE XL switches
The Cisco RPS does not support the Catalyst 2924M XL DC switch.
The Cisco RPS 600 (model PWR600-AC-RPS) provides a quasi-redundant power
source for four external devices that use up to 150W DC each. Use a one-to-one
cable (one connector at each cable end) to connect four external devices to the
four DC output power modules. The power source is quasi-redundant because
there are two AC input power modules for the Cisco RPS and one DC output
power module for each external device. The AC input to the Cisco RPS is fully
redundant, but the DC output to the external devices is not.
Attach only the Cisco RPS (model PWR600-AC-RPS) to the RPS 600 receptacle.
Do not connect the switch power cord to an AC outlet if the switch is also
connected to a powered-on RPS. The switches do not support the fully-redundant
configuration described in the RPS documentation. We do not recommend the
redundant-with-reboot configuration.
For more information on the Cisco RPS 600, refer to the Cisco Redundant Power
System Hardware Installation Guide.
Chapter 1 Product Overview
78-6461-04