When The Expected Images Are Not Projected; Turning The Power Off - Epson EMP-TW 700 User Manual

When the expected images are not projected

If more than one signal source has been connected, or if no images are projected, use the remote control or the
projector's control panel buttons to select the signal source. For video devices, press the [Play] button on the video
equipment first, then select the signal source.
Using the remote control
Press the button that has the name of the port on it that
the desired signal source is connected to.
When projecting an image from the [Component] port
The default setting is set to "Auto" to select appropriate signals automatically. However, if the colours appear unnatural,
switch the image signal to match the equipment.
Using the remote control
While projecting an image from equipment
connected to the [Component] port, press
to display the menu.

Turning the power off

Turn the power off for the signal sources
that are connected to the projector.
Press on the remote control or
the projector's control panel. If you press
on the projector's control panel, the
following message will be displayed.
Press again to continue.
When you press
Use or to select the signal source.
Press to accept.
While projecting an image from equipment
connected to the [Component] port, select
"Component" and confirm to display the menu.
Use or to select the correct signal to
match the equipment.
Press or to accept.
When the projector has cooled down
about 30 seconds), turn off the main power
switch.
on
Simply pressing
electricity consumption.
Attach the lens cover.
Projecting Images
Using the control panel
, the menu is displayed.
Using the control panel
or does not stop
(takes
15