Problems When Projection Starts; Problems With The Remote Control; Projection Stops Automatically; The Remote Control Does Not Work - Epson EMP-TW 700 User Manual

■

Projection stops automatically

Is sleep mode active?

Problems when projection starts

■
Power does not turn on
Have you pressed the [Power]
button?
Is "Child Lock" set to "On"?
Is "Operation Lock" set to "On"? If the "Operation Lock" menu command is set to "On", all buttons
Are all of the indicators
switched off?
Do the indicators turn off and on
when the power cable is
touched?

Problems with the remote control

■

The remote control does not work

Is the remote control light-
emitting area facing towards the
remote control light-receiving
area when it is operated?
Is the remote control too far
from the projector?
Is direct sunlight or strong light
from fluorescent lamps shining
onto the remote control light-
receiving area?
Are the batteries dead, or have
the batteries been inserted
correctly?
When "Sleep Mode" has been set to On, the lamp turns off
automatically if no signal is input for about 30 minutes, and the
projector switches to standby mode. Press the
remote control or the
turn the projector's power back on. To cancel the sleep mode
setting, change "Sleep Mode" menu command to "Off".
"Settings" - "Operation" - "Sleep Mode" p.31
Press on the remote control or
panel.
If the "Child Lock" menu command is set to "On", press
projector's control panel for about 3 seconds or press
remoto control to turn the power on.
"Settings" - "Operation" - "Child Lock" p.31
on the projector's control panel are disabled. Press
remote control.
"Settings" - "Operation" - "Operation Lock" p.31
Disconnect the power cable and then reconnect it.
Check the circuit breaker to see if power is being supplied.
Turn the power off, disconnect the power cable and then reconnect
it. If this does not solve the problem, there may be a problem with
the power cable. Then contact your local dealer or the nearest
address provided in the World-Wide Warranty Terms.
Face the remote control towards the remote control light-receiving
area.
The operating angle for the remote control is approximately ±30°
horizontally and approximately ±30° vertically.
The operating range for the remote control is approximately 10m.
p.13
Set the projector up in a location where strong light will not shine
onto the remote control light-receiving area.
Insert new batteries, while making sure that they face correctly.
p.13
Problem Solving
button on the
button on the projector's control panel to
on the projector's control
on the
on the
on the
p.14
Inquiries
p.13
41