Correcting Projector Tilt; Displaying A Test Pattern - Epson EMP-TW 700 User Manual

Correcting projector tilt

If the projected images are tilted horizontally, use the front adjustable feet to adjust the projector so that it is
horizontal.
Correcting keystone distortion (Keystone)
When you wish to adjust the projection above or below the range of lens shift adjustment set the projector at an
angle.
When the projector is angled, the projected image may distort into a trapezoid. In such cases, press
on the control panel to adjust the images.
However, the image quality will decrease compared to if the lens shift function is used. When the lens is shifted to
the left or right, complete keystone correction is not possible. When making keystone corrections set the lens at the
centre left to right.
Correcting projector tilt
Keystone distortion can be corrected within a maximum vertical angle of approximately 15˚.
You can also make adjustments from the configuration menu.
Correcting keystone distortion
To reset the correction value, press and hold down
(Keystone)
second on the control panel.
TIP

Displaying a test pattern

Displaying a test pattern
You can project a test pattern at times such as when setting up the projector in order to correct keystone correction
and to make line menu adjustments.
You can also adjust the zoom and focus using the test pattern.
If on the remote control is pressed, the test pattern appears.
To stop displaying the test pattern, press
Extend Retract Extend
again.
Adjusting the Projection Screen
Retract
p.31
with pressed down for at least 1
( ) ( )
17