Preparing The Remote Control; Inserting Batteries Into The Remote Control - Epson EMP-TW 700 User Manual

Preparing the Remote Control

Inserting batteries into the remote control

The remote control is not supplied with batteries already inserted. Insert the accessory batteries
before using the remote control.
Remove the battery cover.
While pressing the knob, lift up.
Insert the batteries.
Check the (+) and (-)
indications inside the
battery compartment and
insert the batteries so that
they face correctly.
If delays in the responsiveness of the remote control occur or if it does not operate
after it has been used for some time, it probably means that the batteries are
becoming flat. If this happens, replace the batteries with two new batteries. Use two
TIP
new AA batteries as replacement batteries.
Using the remote control
Operating range (horizontal)
Operating distance
Operating range (vertical)
Approx.10m
Approx.30
Operating distance
Approx.10m
Approx.30
Approx.30
Install the battery cover.
Insert the tab.
Press down until the battery
cover clicks into place.
Remote control light-receiving area
Approx.30 Approx.30
Remote control
light-emitting area
Operating distance
Approx.10m
Approx.30
Approx.30
Approx.30
13