When The Expected Images Are Not Projected; Turning The Power Off - Epson Dreamio EMP-TW1000 U User Manual

When the expected images are not projected

If more than one signal source has been connected, or if no images are projected, use the remote control or the
projector's control panel buttons to select the signal source. For video devices, press the [Play] button on the video
equipment first, then select the signal source.
Using the remote control
When the expected images are not
projected

Turning the power off

Press the button that has the name of the port on it that
the desired signal source is connected to.
When the colour of the image projected from the [D] or [Component] input port
is unnatural, select an appropriate signal according to the signal from the device
connected at "Input Signal" in the Configuration menu.
TIP
Turning the power off
Turn the power off for the signal sources
that are connected to the projector.
Press on the remote control or
the projector's control panel. If you press
on the projector's control panel, the
following message will be displayed.
Press again to continue.
When you press
Each press of
to the target input source to select it.
Press to accept. The input source is automatically
changed if no operations are performed for about 5
seconds with the pointer at the target input source.
When the projector has cooled down
about 30 seconds), turn off the main power
switch.
on
Simply pressing
electricity consumption.
Attach the lens cover.
Projecting Images
Using the control panel
, the menu is displayed.
moves the pointer. Move the pointer
p.34
or does not stop
(takes
15