Table of Contents
Advertisement
LEDs (Front Panel)
Buzzer
Specifications
Page 4
There are five (5) status LEDs on the front panel, as follows:
Ready
Normally ON.
This blinks during Startup or Shutdown, and turns OFF after the
shutdown is completed.
Error
Normally OFF.
(Amber)
However, it will be On during the power-on self test. Once the
self-test is completed, it will turn OFF. If it stays ON, there is a
hardware error.
During a software upgrade, both the Ready and Error LEDs will
blink.
Disk Full
Normally OFF.
Blinking indicates the disk is 98% full.
ON indicates the disk is completely full.
Disk
Flashes during normal operation, when the Hard Disk is ac-
cessed.
LAN
Flashes during normal operation, when data is transmitted or
received via the LAN.
The buzzer will beep as follows:
1 Beep - Reset button or power switch is pressed.
2 Beeps (Repeated every 5 seconds for 1 minute) - Disk Server is a DHCP client,
but no DHCP Server responded to the DHCP client request.
3 Beeps (Repeated every 15 seconds for 3 minutes) - Hard disk usage exceeds
98%.
5 Beeps (Repeated every 15 seconds for 3 minutes) - Overheating; automatic
shutdown will start 3minutes after 1
Dimensions
Operating
Temperature
Storage
Temperature
st
beep.
210mm (W) * 271mm (D) * 66mm (H)
8" (W) * 11" (D) * 3" (H)
5 C to 40 C
-10 C to 60 C
Advertisement
Table of Contents
