Table of Contents
Advertisement
Power Switch
Power Input
Reset IP Button
(IP/Password)
Uplink Button
10/100BaseTX
connector
100BaseTX LED
(amber)
10BaseT LED
(green)
Printer Port
Figure 1: Disk Server Rear Panel
This is a spring-loaded "Soft Switch".
If Off, press once to turn On.
If On, press once to start the Disk Shutdown sequence.
During Shutdown, the Ready LEDs will blink.
Connect the supplied power adapter here.
If the Disk Server's IP Address or password is lost, press and
release this button. The Disk Server will beep once to indi-
cate the reset has o ccurred.
The Disk Server password will be cleared, and its IP Address
set to the default value of 192.168.0.2, with a Network Mask
of 255.255.255.0
You can then connect to the Disk Server and set the correct
IP Address and password.
If connecting directly to a PC or Macintosh via Ethernet,
depress this button.
For normal operation (connecting to a hub), this button
should be UP.
Use this to connect the Disk Server to your 10BaseT or
100BaseTX hub.
This will be ON if the 10/100BaseTX connector is using
100BaseTX.
This will be ON if the 10/100BaseTX connector is using
10BaseT.
Standard parallel printer port. A printer connected here
becomes a "network printer".
Page 3
Advertisement
Table of Contents
