TRENDnet TPE-224WS User Manual page 58

Authentication Port: Sets primary port for security monitoring.
Default is 1812.
Key/Confirm Key: Masked password matching the Radius Server
Key.
TxPeriod: Sets the number of seconds that the switch waits for a
response to an EAP-request/identity frame from the client before
retransmitting the request. Default is 24 seconds.
ReAuthEnabled: This Enable or Disable the periodic
ReAuthentication control. When the 802.1X function is Enabled, the
ReAuthEnabled function is by default also Enabled.
QuietPeriod: Sets the number of seconds that the switch remains in
the quiet state following a failed authentication exchange with the
client. Default 80 seconds.
SuppTimeout: Sets the switch-to-client retransmission time for the
EAP-request frame. Default is 12 seconds.
ServerTimeout: Sets the amount of time the switch waits for a
response from the client before resending the response to the
authentication server. Default is 16 seconds.
MaxReq: This parameter specifies the maximum number of times
that the switch retransmits an EAP Request packet to the client before
it times out the authentication session. Default is 5 times.
ReAuthPeriod: This command affects the behavior of the switch only
if periodic re-authentication is enabled. Default is 3600.
802.1x Port Access Control: Enable or disable the 802.1x port access
on selected port.
52