Table of Contents
Advertisement
A real connection case of TK-RP08
and TK-IP101
Trendnet KVM back panel
Step 2. Make sure that the TK-IP101 and TK-RP08 are powered on. If not, power them up first before
proceeding.
Next, you should access the TK-IP101 Web management interface to set up the various power control
settings....
II. Enable the Power Control Feature on TK-IP101 Web Management
Interface
Step 3. Access the Web Management Interface of your TK-IP101.
And from there, you can then go forth to (1) enable the power control feature of TK-IP101, and then (2)
configure the Power control commands for each and every port on the TK-RP08. (
Also please refer to TK-
)....
IP101 User Guide, Section 4.11, KVM Server/Power Control – Enable the power control.
Step 4. Go to the Power Control page. Then Enable and Select various Power Control features.
The Power Control page allows you to enable or disable the power control feature via the serial port on the back panel
of your TK-IP101. (Also please refer toTK-IP101 User Guide, Section 4.11, KVM Server/Power Control – Enable the
power control.)
-
-
89
Advertisement
Table of Contents
