DirecTV D10 User Manual page 73

Remote Control Problems
Problems with the remote control
4 Check that nothing is between the remote control and the remote sensor.
Make sure the remote control is in DIRECTV mode. Slide the mode switch to the
4
DIRECTV position so the remote will control the DIRECTV Receiver.
Check the batteries in the remote control. They may be weak, dead or installed
4
incorrectly. Try replacing batteries.
4 If you're entering a channel number that is less than four digits long, the receiver might
wait two seconds before tuning to the channel. Press ENTER after entering a channel
number to tune immediately.
4 If you are trying to operate a device other than the DIRECTV Receiver that you have
programmed the remote to control, make sure you fi rst slide the input switch to the
corresponding device (AV1, AV2 or TV). The indicator light for the component you're
trying to control should light up when you press a valid key for that component. If it
doesn't, make sure the input switch is clicked into the correct position.
A remote control indicator light starts fl ashing.
The batteries in the remote control are running low and should be replaced soon. (Note that when
you replace the batteries, you may have to reprogram your remote to control other devices.)
Troubleshooting
65
Chapter 5