DirecTV D10 User Manual page 24

Getting Connected
TIP
To switch between watching
your VCR and watching video
from your receiver, you will
need to use the INPUT, SOURCE,
or TV/VIDEO button on your TV
or TV's remote control to change
the video source. Some TVs also
have a MENU button that allows
you to change the video source
using an on-screen menu. If you
have trouble changing the video
source refer to the instructions
that came with your TV.
16
Choose the Setup That Suits You
Connecting Your DIRECTV Receiver to a TV
with A/V and S-Video Inputs
1) Connect the RG-6 RF coaxial cable from your satellite dish to the jack labeled
SATELLITE IN on the DIRECTV Receiver.
2) Using the S-Video cable, connect one end to the S-VIDEO output jack on the DIRECTV
Receiver and the other end to the S-VIDEO input jack on the TV.
3) Using the A/V cable, connect the white and red plugs from one end of the A/V cable to
the AUDIO L (white) and R (red) jacks on the back of the DIRECTV Receiver. Connect
the plugs from other end of the A/V cable to the corresponding input jacks on your TV.
Do not plug the video (yellow) into either the DIRECTV Receiver or the TV.
4) Plug one end of the telephone cord into a phone jack on your wall (or into a phone splitter
that is plugged into a phone jack) and the other end into the PHONE JACK on the back
of the DIRECTV Receiver.
5) Plug all power cords into electrical sockets.
Now you can turn to page 26 to learn about Guided Setup and Activation.
Note
If your TV only has one audio input jack use the AUDIO L (white) jack on the back of the DIRECTV Receiver to make
the connection.