Denon AVR-4311CI Owner's Manual page 97

n Steps for setting "Amp Assign"
This unit is provided with ten types of Assign Mode settings.
You can switch the channels assigned to a power amplifier in accordance with your speaker system or perform playback using up to 11
channels using a combination of the built-in power amplifier for 9-channel and an external power amplifier for 2-channel. You can also use
this unit as a preamplifier.
Use the following flowchart to set the speaker system of this unit.
Select the method for using a power amplifier in accordance with your
Z2/3-
NORMAL ZONE2 Bi-AMP
MONO
"Assign Sp." settings
Select the speaker terminal from which to output the signals
assigned to the power amplifier (vpage 95 – [2]).
S.BACK F.HEIGHT
9.2ch 7.2ch 7.2ch
(5.2 + SB + FH) (5.2 + FH) (5.2 + SB)
(5.2 + SB + FW) (5.2 + FW) (5.2 + FW)
Maximum number of channels that can be used for the MAIN ZONE audio
94
Remote control operation
buttons
"Assign Mode" settings
speaker system (vpage 95 – [1]).
2CH Bi-
2CH Front B ZONE2/3
AMP
Select a channel that
uses the PRE OUT
connector (vpage 95
F.WIDE Height
7.2ch 7.2ch 11.2ch
(5.2 + SB) (5.2 + SB) (9.2 + Height
(5.2 + FH) (PRE OUT))
5.2ch
Move the cursor
(Up/Down/Left/Right)
MANUAL SETUP
PRE
11CH
AMP
"Ext. Amp" "Assign Sp."
settings settings
Set whether or not
to use the speaker
terminals for multizone
– [3]). (vpage 95 – [4]).
Front None ZONE2/3
11.2ch 11.2ch
(9.2 + Front (PRE OUT)
(PRE OUT))
Confirm the setting Return to previous menu