Denon AVR-4311CI Owner's Manual page 116

Erasing the code by each equipment input source
1
Press and hold POWER ON and
ZONE/DEVICE ON for at least 3
seconds.
"SETUP" flashes twice on the remote
control unit.
2
Use ui to display "RESET"
on the remote control unit and
press ENTER .
3
When "LEARN" appears on
the remote control unit, press
ENTER .
4
When "MODE?" appears on the
remote control unit, press the
input source select button of the
AV equipment that you want to
erase.
5
When "ALL?" appears, press ENTER
"RESET" flashes four times on the remote control unit and the
normal operation mode is restored.
Operating macro function
• When the macro function is used, operations that usually require a
complicated series of multiple button operations can be performed
easily just by pressing the
• This device can remember up to 3 macro functions.
• Each macro can record a maximum of 18 steps.
[Example] All system power on
q Turn the TV's power on
↓
w Turn this unit's power on
↓
e Switch this unit's input source to DVD
↓
r Turn the DVD's power on
n Recording macro operations
1
Press and hold
for at least 3 seconds.
"SETUP" flashes twice on the remote control unit.
2
Use ui to display "MACRO"
.
on the remote control unit and
ENTER
press .
3
When "MCNo? " appears on the
remote control unit, press the
QUICK SELECT
want to store.
Button
QUICK SELECT 1
QUICK SELECT 2
QUICK SELECT 3
4
Press the buttons to be stored one
by one.
• The step number for the storing procedure and mode are alternately
displayed on the remote control unit.
• You cannot store the macros for the
SELECT BACK LIGHT
and
5
Press MACRO
"SET" flashes four times on the remote control unit and the
normal operation mode is restored.
MACRO
button.
POWER ON ZONE/DEVICE ON
and
button that you
Macro number
MACRO-1
MACRO-2
MACRO-3
ZONE SELECT SOURCE
,
buttons.
to exit the macro function.
Operating the main remote control unit
n Adjusting the interval time of macro operations
transmitting
The macro operation transmission interval can be adjusted.
• The factory setting is "0.5 sec".
1
POWER ON
Press and hold and
ZONE/DEVICE ON for at least 3
seconds.
"SETUP" flashes twice on the remote
control unit.
2
Use ui to display "MACRO"
on the remote control unit and
ENTER
press .
3
When "MCNo?" appears on the
remote control unit, press the
QUICK SELECT button that you
want to set.
Button Macro number
QUICK SELECT 1 MACRO-1
QUICK SELECT 2 MACRO-2
QUICK SELECT 3 MACRO-3
4
MACRO
Press many times to set the macro operation
transmission interval and press ENTER
"SET" flashes four times on the remote control unit and the
normal operation mode is restored.
Time values that you can
Remote control unit display
0.25
0.50
0.75
1.00
1.25
.
set
0.25 sec
0.5 sec
0.75 sec
1 sec
1.25 sec
113