Denon AVR-4311CI Owner's Manual page 115

Operating learning function
If the AV device is not a DENON device, or if the device does not
operate even when the preset code is registered, use the learning
function. Remote codes for different devices can be remembered for
use by the DENON remote control included with this device.
n Remembering remote control codes from other
devices
1
POWER ON
Press and hold and
ZONE/DEVICE ON for at least 3
seconds.
"SETUP" flashes twice on the remote
control unit.
2
Use ui to display "LEARN" on
the remote control unit and press
ENTER
.
3
When "MODE?" appears on the
remote control unit, press the
input source select button of the
AV equipment that you want to
store.
• You cannot store the remote control code in
AMP
the button.
4
When "KEY? " appears on the remote control unit,
press the button that you want to store.
• You cannot store the remote control code in the
POWER OFF ZONE SELECT SOURCE SELECT
, ,
SELECT 1 – 3 BACK LIGHT
, and input source select button.
112
5
When "SEND " appears on the remote control unit,
place the remote control unit of the AV equipment
face to face with main remote control unit (of this
unit). Next, press and hold down the desired button
(that you want to store) of the remote control unit of
the AV equipment.
• When the button is correctly stored, "OK" flashes four times on
the remote control unit.
• If the button is not correctly stored, "FAIL" flashes four times on
the remote control unit. If this happens, perform step 4 again.
6
To store another button, repeat steps 4 and 5.
7
When you have finished storing the remote control
codes, press
"SET" flashes four times on the remote control unit and the
normal operation mode is restored.
POWER ON
,
• There are some remote control units that cannot be programmed,
MACRO QUICK
, ,
or even if they can be programmed, they may not operate correctly.
If this happens, use the remote control unit supplied with the AV
equipment to operate it.
• The operations of the programmed buttons override the preset
memory. If you do not require the programmed buttons, erase
the stored remote control codes to return to the initial settings
(vpage 112 "Operating learning function").
• The number of buttons that can be stored varies depending on the
remote control unit used. If you have stored the maximum number
of buttons allowed for the remote control unit, "FAIL" appears on
its display.
POWER ON .
Operating the main remote control unit
n Erasing stored remote control codes
Erasing the code by each button
1
POWER ON
Press and hold and
ZONE/DEVICE ON for at least 3
seconds.
"SETUP" flashes twice on the remote
control unit.
2
Use ui to display "RESET" on
the remote control unit and press
ENTER .
3
When "LEARN" appears on the
remote control unit, press ENTER
4
When "MODE?" appears on the
remote control unit, press the
input source select button of the
AV equipment that you want to
erase.
5
Use ui to display "ONE?" on the remote control
unit and press ENTER .
6
When "KEY?" appears on the remote control unit,
press the button that you want to erase.
"RESET" flashes four times on the remote control unit and the
normal operation mode is restored.
.