Checking The Sirius Signal Strength And Radio; Presetting Radio Channels (Preset Memory); Listening To Preset Channels - Denon AVR-3808CI Owner's Manual

ENGLISH
Symbols used to indicate buttons in this manual
Button located on both the main unit
and the remote control unit
Button only on the main unit
Button only on the remote control unit
<Illustration : AVR-4308>
<SOURCE SELECT><TUNING PRESET>
uio p
[A ~ G]
[ENTER]
[SEARCH]
[CHANNEL + –]
[NUMBER]
[SOURCE SELECT]

Checking the SIRIUS Signal Strength
and Radio ID
BUTTON
1
Either turn
<BUTTON>
select "SIRIUS".
[BUTTON]
b When operating via the remote control unit, you cannot select
SIRIUS even by pressing
been assigned.
<STATUS>
2
<STATUS>
Press
display.
The display will switch as shown below, depending on the
reception conditions.
Display
EXCELLENT
GOOD
WEAK
NO SIGNAL
3
Adjust the position of the antenna until "SIGNAL:
EXCELLENT" is shown on the display.
4
<STATUS>
Press
"SR001") is displayed.
[ TU]
5
[
Press
( mode)
Channel No. and Sirius ID are alternately shown on the display.
SR000 SiriusID
[ ]
b Write your own SIRIUS ID for storage use.
[MEMO]
Sirius ID :
uio p
The strength of both the SIRIUS satellite and terrestrial signals can
be checked at GUI menu "Source Select" – "SIRIUS" – "Antenna
Aiming" (vpage 6).
[SAT TU]
(AMP mode)
<SOURCE SELECT> [SAT TU]
or press
[SOURCE SELECT]
to which SIRIUS has
until "SIGNAL" appears on the
Status
Signal strength is excellent
Signal strength is good
Signal strength is weak
No signal
until the channel (example:
]
and select channel 0 (SR000).
Sirius ID
************
Presetting Radio Channels
(Preset Memory)
Your favorite broadcast channels can be preset so that you can
to
tune them in easily. Up to 56 channels can be preset.
1
Tune in the broadcast channel you want to preset.
2
[MEMO]
Press .
3
[A ~ G]
Press to select the block in which the channel
is to be preset.
4
[CHANNEL + –] [NUMBER (1 ~ 8)]
Press or
the preset number.
5
[MEMO]
Press again to complete the setting.
To preset other channels, repeat steps 1 to 5.
NOTE
Preset channels are erased by overwriting them.

Listening to Preset Channels

Operation on the Main Unit
<TUNING PRESET>
Press , then turn
to select the preset channel.
Operation on the Main Remote control Unit
1
[CHANNEL + –]
Press .
A pop-up window appears.
2
Select a preset channel using
3
[ENTER]
Press .
[0 ~ 8]
Selection is still possible if you press
to select
<SOURCE SELECT>
[CHANNEL + –]
.
[A ~ G]
after pressing .