D-Link DES-6000 User Manual page 65

Modular Ethernet Switch User's Guide
This screen allows you to Enable or Disable Group VLAN Registration Protocol (GVRP) for each port. When
GVRP is Enabled, a user attached to the port's Ethernet segment can dynamically join an 802.1Q VLAN that
has been previously defined on the switch. When GVRP is Disabled, then no dynamic VLAN registration is
allowed on this port.
Choose Configure 802.1Q Static VLANs to access the fourth item on the 802.1Q VLAN Configuration
menu. The following screen appears:
The fields you can set are:
♦ VID Enter a VLAN ID from 1 to 4094. This is the VLAN that will be defined on this screen. VID 1 is the
default VLAN. All ports are designated members of VID 1 when VLANs are enabled.
♦ VLAN Name Description of the VLAN.
♦ Tag/Untag Toggle between T for Tagging Port and U for Untagging Port for each member port.
♦ Egress/Forbidden/Non-Member Position the cursor over the dash "–" representing the appropriate
port number and press <space bar> to select E for Egress, F for Forbidden or leave the dash "–". An E
designates the specified port as a static member of the VLAN. An F defines the port as a non-member and
also forbids the port from joining a VLAN dynamically. A dash (–) means the port is not given VLAN
membership for the VID entered above.
♦ Clear Erases the VLAN name and deselects any Egress or Forbidden settings.
Choose Browse 802.1Q VLANs at the bottom of the 802.1Q Static VLAN Settings screen to access the
following screen:
60
Figure 6-40. 802.1Q Static VLAN Settings screen
Using the Console Interface