D-Link DES-6000 User Manual page 56

Modular Ethernet Switch User's Guide
Configure MAC Address Filtering
The Static Filtering Table contains filtering information configured into the Switch by (local or network)
management specifying MAC addresses which are not allowed to be forwarded. The Switch will check both
the destination and source MAC addresses on all packets.
To access the Static Filtering Table, select Configure Filtering and Forwarding Table from the System
Configuration menu. Then select Configure MAC Address Filtering from the bottom of the Configure
Filtering and Forwarding table screen. The following screen appears:
Figure 6-24. Static Filtering Table screen
To make a change to the Static Filtering Table, choose Add or Remove in the Action field. Then enter the
MAC Address and VID (if Port-based or 802.1Q VLANs are enabled) and then press APPLY.
Configure Static Multicast Filtering
Multicast filtering allows you to block or forward traffic over each port for one multicast group.
To access the Static Multicast Filtering Configuration screen, select Configure Filtering and
Forwarding Table from the System Configuration menu. Then select Configure Static Multicast
Filtering from the bottom of the Configure Filtering and Forwarding table screen. The following screen
appears:
Figure 6-25. Static Multicast Filtering Configuration screen
Using the Console Interface 51