D-Link DES-6000 User Manual page 104

Modular Ethernet Switch User's Guide
Use this window to enable or disable the ingress filtering check for each desired port. Ingress filtering means
that a receiving port will check to see if it is a member of the VLAN ID in the packet before forwarding the
packet. Click Apply to let the settings take effect.
Click on the Port VLAN ID (PVID) icon to access the following window:
This screen allows you to set a Port VLAN ID number (PVID) for each port. VLAN 1 is the default VLAN. All
ports are assigned PVID = 1 when VLANs are enabled.
Note: If a port is a member of a trunk group but is not the anchor, the items shown in the above table
will be read-only and the values will be the same as those for the anchor port.
Click Apply to let the settings take effect.
Web-Based Network Management
Figure 7-31. Port Ingress Filter window
Figure 7-32. Port VLAN ID (PVID) window
99