System Log Settings - D-Link DES-3028 User Manual

DES-3028 DES-3028P DES-3028G DES-3052 DES-3052P Layer 2 Fast Ethernet Managed Switch

System Log Settings

The Switch can send Syslog messages to up to four designated servers using the System Log Server. To view this window click
Administration > System Log Settings, to view the window shown below.
The parameters configured for adding and editing System Log Server settings are the same. See the table below for a description.
The following parameters can be set:
Parameter
Index
Host IP
Severity
Facility
Figure 6- 16. System Log Host window
Figure 6- 17. System Log Host – Add window
Description
Syslog server settings index (1-4).
The IP address of the Syslog server.
This drop-down menu allows you to select the level of messages that will be sent. The options
are Warning, Informational, and All.
Some of the operating system daemons and processes have been assigned Facility values.
Processes and daemons that have not been explicitly assigned a Facility may use any of the
"local use" facilities or they may use the "user-level" Facility. Those Facilities that have been
designated are shown in the following: Bold font indicates the facility values that the Switch is
currently employing.
Numerical Facility
Code
45