D-Link DES-3028 User Manual page 172

DES-3028 DES-3028P DES-3028G DES-3052 DES-3052P Layer 2 Fast Ethernet Managed Switch
To add an entry to the Access Profile Table, click the Add button. This will open the Access Profile Configuration window, as
shown below. There are three Access Profile Configuration windows; one for Ethernet (or MAC address-based) profile
configuration, one for IP address-based profile configuration and one for the Packet Content Mask. You can switch between the
three Access Profile Configuration windows by using the Type drop-down menu or clear all entries by clicking the Clear All
button. The window shown below is the Access Profile Configuration window for Ethernet.
Note: The Profile ID is used for relative priority for an Access Profile should a conflict arise between
a rule created in one profile and a rule created in a different profile. Please read the CLI Reference
Manual chapter discussing Access Control List (ACL) Commands.
The following parameters can be set, for the Ethernet type:
Parameter
Profile ID (1-256)
Type
VLAN
Source MAC
Destination MAC
802.1p
Figure 9- 3. Access Profile Configuration window (Ethernet)
Description
Type in a unique identifier number for this profile set. The number is used to set the relative
priority for the profile. Priority is set relative to other profiles where the lowest profile ID has
the highest priority. If a conflict occurs among configured access rules, the profile ID
establishes relative priority of the rules. The value can be set from 1 to 256 however there is
a limit to the total number of profiles that can be created.
Select profile based on Ethernet (MAC Address), IP address or packet content mask. This
will change the menu according to the requirements for the type of profile.
Select Ethernet to instruct the Switch to examine the layer 2 part of each packet

header.
Select IP to instruct the Switch to examine the IP address in each frame's

header.
Select Packet Content Mask to specify a mask to hide the content of the packet

header.
Selecting this option instructs the Switch to examine the VLAN identifier of each packet
header and use this as the full or partial criterion for forwarding.
Enter a MAC address mask for the source MAC address.
Enter a MAC address mask for the destination MAC address.
Selecting this option instructs the Switch to examine the 802.1p priority value of each packet
header and use this as the, or part of the criterion for forwarding.
158