HP-GL/2 jobs are printed 6 mm larger than specied
The page size of the HP-GL/2 print job, as created in
the source application, is incorrect.
HP-GL/2 jobs are printed at maximum size, even if a
standard size is specied
The page size of the HP-GL/2 print job, as created in
the source application, is incorrect.
HP-GL/2 printing takes a long time
Large print jobs with a lot of data take longer to print. Please wait a while until printing is nished.
A job was printed when Input Resolution in the
Control Panel menu was set to 600dpi.
Replotting with HP-GL/2 jobs is not possible.
The data was lost because of replotting.
The printer stops when printing a HP-GL/2 job (the
carriage stops moving)
The printer is analyzing the print job.
A job was printed when Input Resolution in the
Control Panel menu was set to 600dpi.
Cause
Cause
Cause
Cause
Cause
Corrective Action
In the Control Panel menu, set PageSizeProcess1
to On.
(→P.49)
Corrective Action
In the Control Panel menu, set PageSizeProcess2
or Conserve Paper to On.
The layout will be changed to the optimal layout.
(→P.49)
Corrective Action
In the Control Panel menu, set Input Resolution to
300dpi and print again.
(→P.49)
Corrective Action
Data for replotting is lost after the following
operations. In this case, send the print job again.
•
The memory buffer was cleared from the Control
Panel.
•
The printer was turned off.
•
The printer has received a new HP-GL/2 print job.
•
Printing has been canceled
Corrective Action
Please wait a while until printing is nished.
In the Control Panel menu, set Input Resolution to
300dpi and print again.
(→P.49)
HP-GL/2 problems
Troubleshooting 683